INDUSTRIAL HYGIENIST / CHEMICAL ENGINEER (INTERDISCIPLINARY)

Duties
Help

• You will analyze accident and injury reports to discover trends and mishap causes to develop recommendations for reducing or eliminating the hazards.
• You will apply industrial hygiene principles to control occupational health hazards associated with shipyard industrial work situations.
• You will review and provide comments, technical guidance for a wide variety of local and higher authority instructions, procedures, and regulations (e.g., Uniform Industrial Process Instructions, Industrial Process Instructions, and etc.)
• You will act as the PSNS point of contact (POC) for matters concerning the program(s) managed, including speaking for PSNS at meetings with the civilian and military workforce and off station representatives from OPNA V and NAVSEA.
• You will be responsible for data processing, review, and analysis as necessary to ensure program-related reports are accurate and portrayed for outside departments to easily understand.

Requirements
Help
Conditions of employment

• Must be a US Citizen.
• Must be determined suitable for federal employment.
• Must participate in the direct deposit pay program.
• New employees to the Department of the Navy will be required to successfully pass the E-Verify employment verification check. To learn more about E-Verify, including your rights and responsibilities, visit e-verify.gov
• Within the Department of Defense (DoD), the appointment of retired military members within 180 days immediately following retirement date to a civilian position is subject to the provisions of 5 United States Code 3326.
• Males born after 12-31-59 must be registered for Selective Service.
• This is a bargaining unit position.
• You will be required to obtain and maintain an interim and/or final security clearance prior to entrance on duty. Failure to obtain and maintain the required level of clearance may result in the withdrawal of a job offer or removal.
• You will be required to wear personal protective equipment such as helmets, gloves, coveralls, glasses, goggles, respirators and safety shoes continuously for the duration of the work shift.
• Work is performed in areas where potentially harmful physical and chemical agents are present (e.g. fumes, dust, heat, ionizing and non-ionizing radiation and chemicals). You will be required to participate in medical surveillance programs.
• This position may require travel from normal duty station to CONUS and OCONUS and may include remote or isolated sites. You must be able to travel on military and commercial aircraft for extended periods of time.
• Work may take place in confined and enclosed spaces (tanks, voids, utility tunnels, etc.) both shipboard and ashore.

Qualifications

GS-0690/0893-07 - Your resume must demonstrate at least one year of specialized experience equivalent to the next lower grade level (GS-05) or pay band in the federal service or equivalent experience in the private or public sector as a Professional Industrial Hygienist or Professional Chemical Engineer, assisting with conducting surveys or interviews to evaluate health hazards in industrial shops or similar work areas.

For the GS-07 Only: In lieu of specialized experience, you may qualify for the GS-07 Grade Level with the following education or combination of both education and experience:

Successful completion of one full year of graduate level education. https://www.usajobs.gov/Help/working-in-government/unique-hiring-paths/students/federal-occupations-by-college-major/

OR

Successful completion of a bachelor's degree with superior academic achievement.

OR

A combination of experience and education that equates to one year of experience.

GS-0690-05:

A. A bachelor's or graduate/higher level degree in industrial hygiene, occupational health sciences, occupational and environmental health, toxicology, safety sciences, or related science

OR

B. A bachelor's degree in a branch of engineering, physical science, or life science that included 12 semester hours in chemistry, including organic chemistry, and 18 additional semester hours of courses in any combination of chemistry, physics, engineering, health physics, environmental health, biostatistics, biology, physiology, toxicology, epidemiology, or industrial hygiene.

OR

C. Certification from the American Board of Industrial Hygiene(external link) (ABIH).

GS-0893-05:

A. Degree: Engineering. To be acceptable, the program must: (1) lead to a bachelor's degree in a school of engineering with at least one program accredited by ABET; or (2) include differential and integral calculus and courses (more advanced than first-year physics and chemistry) in five of the following seven areas of engineering science or physics: (a) statics, dynamics; (b) strength of materials (stress-strain relationships); (c) fluid mechanics, hydraulics; (d) thermodynamics; (e) electrical fields and circuits; (f) nature and properties of materials (relating particle and aggregate structure to properties); and (g) any other comparable area of fundamental engineering science or physics, such as optics, heat transfer, soil mechanics, or electronics.

OR

B. Combination of education and experience -- college-level education, training, and/or technical experience that furnished (1) a thorough knowledge of the physical and mathematical sciences underlying engineering, and (2) a good understanding, both theoretical and practical, of the engineering sciences and techniques and their applications to one of the branches of engineering. The adequacy of such background must be demonstrated by one of the following:

Professional registration or licensure -- Current registration as an Engineer Intern (EI), Engineer in Training (EIT)1 , or licensure as a Professional Engineer (PE) by any State, the District of Columbia, Guam, or Puerto Rico. Absent other means of qualifying under this standard, those applicants who achieved such registration by means other than written test (e.g., State grandfather or eminence provisions) are eligible only for positions that are within or closely related to the specialty field of their registration. For example, an applicant who attains registration through a State Board's eminence provision as a manufacturing engineer typically would be rated eligible only for manufacturing engineering positions.

Written Test -- Evidence of having successfully passed the Fundamentals of Engineering (FE)2 examination or any other written test required for professional registration by an engineering licensure board in the various States, the District of Columbia, Guam, and Puerto Rico.

Specified academic courses -- Successful completion of at least 60 semester hours of courses in the physical, mathematical, and engineering sciences and that included the courses specified in the basic requirements under paragraph A. The courses must be fully acceptable toward meeting the requirements of an engineering program as described in paragraph A.

Related curriculum -- Successful completion of a curriculum leading to a bachelor's degree in an appropriate scientific field, e.g., engineering technology, physics, chemistry, architecture, computer science, mathematics, hydrology, or geology, may be accepted in lieu of a bachelor's degree in engineering, provided the applicant has had at least 1 year of professional engineering experience acquired under professional engineering supervision and guidance. Ordinarily there should be either an established plan of intensive training to develop professional engineering competence, or several years of prior professional engineering-type experience, e.g., in interdisciplinary positions. (The above examples of related curricula are not all-inclusive.)

Additional qualification information can be found from the following Office of Personnel Management website:

General Schedule Qualification Standards

OR

Industrial Hygiene Series 0690

OR

Chemical Engineering Series 0893

Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., professional, philanthropic, religious, spiritual, community, student, social). Volunteer work helps build critical competencies, knowledge, and skills and can provide valuable training and experience that translates directly to paid employment.

Education

Applicants must meet the following positive education qualifications requirements of the Office of Personnel Management (OPM) Qualifications Standards Manual.

Applicants must possess for the GS-0690, Industrial Hygiene Series:

A. A bachelor's or graduate/higher level degree in industrial hygiene, occupational health sciences, occupational and environmental health, toxicology, safety sciences, or related science.

OR

B. A bachelor's degree in a branch of engineering, physical science, or life science that included 12 semester hours in chemistry, including organic chemistry, and 18 additional semester hours of courses in any combination of chemistry, physics, engineering, health physics, environmental health, biostatistics, biology, physiology, toxicology, epidemiology, or industrial hygiene

OR

C. Certification from the American Board of Industrial Hygiene(external link) (ABIH).

Applicants must possess for the GS-0893, Chemical Engineer Series:

A. Degree: Engineering. To be acceptable, the program must: (1) lead to a bachelor's degree in a school of engineering with at least one program accredited by ABET; or (2) include differential and integral calculus and courses (more advanced than first-year physics and chemistry) in five of the following seven areas of engineering science or physics: (a) statics, dynamics; (b) strength of materials (stress-strain relationships); (c) fluid mechanics, hydraulics; (d) thermodynamics; (e) electrical fields and circuits; (f) nature and properties of materials (relating particle and aggregate structure to properties); and (g) any other comparable area of fundamental engineering science or physics, such as optics, heat transfer, soil mechanics, or electronics.

OR

B. Combination of education and experience -- college-level education, training, and/or technical experience that furnished (1) a thorough knowledge of the physical and mathematical sciences underlying engineering, and (2) a good understanding, both theoretical and practical, of the engineering sciences and techniques and their applications to one of the branches of engineering. The adequacy of such background must be demonstrated by one of the following:

Professional registration or licensure -- Current registration as an Engineer Intern (EI), Engineer in Training (EIT)1 , or licensure as a Professional Engineer (PE) by any State, the District of Columbia, Guam, or Puerto Rico. Absent other means of qualifying under this standard, those applicants who achieved such registration by means other than written test (e.g., State grandfather or eminence provisions) are eligible only for positions that are within or closely related to the specialty field of their registration. For example, an applicant who attains registration through a State Board's eminence provision as a manufacturing engineer typically would be rated eligible only for manufacturing engineering positions.

Written Test -- Evidence of having successfully passed the Fundamentals of Engineering (FE)2 examination or any other written test required for professional registration by an engineering licensure board in the various States, the District of Columbia, Guam, and Puerto Rico.

Specified academic courses -- Successful completion of at least 60 semester hours of courses in the physical, mathematical, and engineering sciences and that included the courses specified in the basic requirements under paragraph A. The courses must be fully acceptable toward meeting the requirements of an engineering program as described in paragraph A.

Related curriculum -- Successful completion of a curriculum leading to a bachelor's degree in an appropriate scientific field, e.g., engineering technology, physics, chemistry, architecture, computer science, mathematics, hydrology, or geology, may be accepted in lieu of a bachelor's degree in engineering, provided the applicant has had at least 1 year of professional engineering experience acquired under professional engineering supervision and guidance. Ordinarily there should be either an established plan of intensive training to develop professional engineering competence, or several years of prior professional engineering-type experience, e.g., in interdisciplinary positions. (The above examples of related curricula are not all-inclusive.)

Must have the following minimum educational requirements from SECNAVINST 5100.16C: In all cases the candidate's education shall include a minimum of thirty credits of laboratory sciences with at least college-level courses in general inorganic chemistry (two semesters of lectures and labs addressing qualitative and quantitative analysis methods) and organic chemistry (one semester of lecture and lab addressing qualitative and quantitative analysis methods). The remaining credit hours of courses may be in any combination of chemistry, physics, engineering, health physics, environmental health, biostatistics, biology, physiology, toxicology, epidemiology, or industrial hygiene. Courses in the history or teaching of chemistry are not acceptable.

Additional information

This position is covered by the Department of Defense Priority Placement Program.

This announcement uses the Defense Industrial Base, Major Range and Test Facilities direct hire authority to recruit and appoint qualified candidates to certain positions in the competitive service.

Several vacancies may be filled.

Vacancies filled from this announcement may be filled at any grade level listed.

If selected below the full performance level, you may be noncompetitively promoted to the next higher grade level after meeting all regulatory requirements, and upon the recommendation of management. Promotion is neither implied nor guaranteed.

This position is subject to work an uncommon tour, including nights, weekends, and holidays to meet mission requirements. Overtime or night differential pay and/or unusual duty hours may be required.

A tentative offer of employment will be rescinded if the selectee fails to meet the pre-employment requirements, including failure to report to any of the scheduled appointments.

Federal annuitant information: The selection of an annuitant is subject to the Department of Defense and Department of the Navy policy on the employment of annuitants. Policy information may be found at: http://www.secnav.navy.mil/donhr/Documents/CivilianJobs/FedCivAnnuitants.pdf .

Veteran's preference does not apply when selecting individuals under this specific hiring authority. However, if you claim veteran's preference, you will be required to submit supporting documentation with your application as described in the Required Documents section below.